Changing the settings Switching the backspin length It is possible to make the unit perform back spin longer than the actual jog wheel rotation amount when back spin operation of jog wheel is performed. The length of back spin operation can be selected from one of three types: short, normal, and long. ! By default, back spin length normal is set. Press any of performance pads 6 to 8 on the right deck. Pad 6 lit: Back spin length normal Pad 7 lit: Back spin length short Pad 8 lit: Back spin length long Adjusting the sensitivity of the jog wheel touch sensor This unit is equipped with a mode for adjusting the sensitivity of the jog wheel touch sensor. ! The value set in the jog wheel sensitivity adjustment mode is retained even when this unit is turned off. ! The sensitivity of the left and right jog wheel can be adjusted separately. The following example describes the procedure for adjusting the sensitivity of the jog wheel on the left deck. 1 Connect this unit to the PC/Mac via an included USB cable. 2 Press the [DECK1] or [DECK3] button while pressing the [SHIFT] button. The sensitivity adjustment mode is set, and the current sensitivity is displayed on the indicator in the center area of the jog wheel. ! During the sensitivity adjustment mode, perform the next operation within 3 seconds. (If more than 3 seconds pass after a button was pressed, the set value is stored and the indicator returns to the normal display.) 3 Press the [DECK1] or [DECK3] button while pressing the [SHIFT] button. The sensitivity increases each time the [DECK1] button is pressed and decreases each time the [DECK3] button is pressed. When the jog wheel sensitivity is adjusted, the set sensitivity is displayed on the indicator in the center area of the jog wheel. Disabling optimization of crossfader MIDI messages When the [CROSS FADER CURVE] switch on the front panel is set to , the crossfader MIDI messages output method is optimized to improve crossfader response during scratching. With this setting, optimization of crossfader MIDI messages is disabled. ! By default, optimization of crossfader MIDI messages is enabled. ! Optimization of crossfader MIDI messages is performed only when the [CROSS FADER CURVE] switch is set to . Press the [KEY LOCK] button on the left deck. ! [KEY LOCK] button lit: Optimization of crossfader MIDI messages is enabled. ! [KEY LOCK] button off: Optimization of crossfader MIDI messages is disabled. Low sensitivity (–10) No adjustment (±0) High sensitivity (+10) The jog wheel sensitivity can be adjusted in 37 steps. ! By default, “No adjustment (±0)” is set. ! To adjust the sensitivity of the jog wheel on the right side, press the [DECK2] or [DECK4] button while pressing the [SHIFT] button. 4 After setting is completed, wait for 3 seconds. When 3 seconds have passed after pressing the button, the set value is stored and the indicator returns to the normal display. Launching the setting utility software automatically When connecting the USB cable to PC/Mac, the setting utility software on the PC/Mac can be launched automatically. By default, the setting utility software is not launched automatically. Press the [KEY LOCK] button on the right deck. ! [KEY LOCK] button lit: the setting utility software is launched automatically. ! [KEY LOCK] button off: the setting utility software is not launched automatically. En 35
Download PDF file
Table of contents