3 While pressing the [SHIFT] button, move the crossfader in the opposite direction from the left edge or right edge. Playback of the track starts from the set cue point. ! When the crossfader is returned to the original position while pressing the [SHIFT] button during playback, the track moves instantaneously back to the set cue point and the pause mode is set (Back Cue). ! If no cue is set, playback starts from the beginning of the track. ! When the crossfader is moved from the left edge to the right edge (or from the right edge to the left edge) while pressing the [SHIFT] button when standing by at a cue, track playback starts from the set cue point. 1 1 1 23 54 54 54 Single FX mode: One effect can be selected per effect unit and there are multiple adjustable parameters. 1 23 Using the velocity sampler When velocity sampler mode is on, the sample volume level changes according to the amount of force used to tap the performance pads. The volume level increases when the performance pads are tapped strongly and decreases when they are tapped weakly. When velocity sampler mode is off, the sound is triggered at the volume level set using the Serato DJ Pro software, regardless of the amount of force used to tap the performance pads. Turning the velocity sampler mode on When the [SAMPLER] mode button is pressed for 1 second or longer, the velocity sampler mode is turned on. Turning the velocity sampler mode off When the [SAMPLER] mode button is pressed, the mode is changed to the usual sampler mode (velocity sampler mode is turned off). ! In the utilities mode, the velocity curve and after-touch function can be set. When after-touch is enabled, the sample volume level changes while the performance pad is being pressed according to the force used to press on the pad. “Changing the velocity curve setting of velocity sampler mode” (p.33) “Enabling the after-touch setting in velocity sampler mode” (p.34) 5444 44 1 This displays the effect type. 2 This displays the effect time. 3 This displays the number of the deck to which the effect unit is assigned. 4 This displays the effect parameter status. 5 This displays whether the effect is on or off. Operating in the multi FX mode 1 Switch the DJ-FX mode to the multi FX mode on the Serato DJ Pro screen. Display the [FX] panel, and then click the multi FX mode. 2 Press the [CH ASSIGN] button on the left deck to select the deck to be assigned. Analyzing tracks When tracks are loaded onto the decks by pressing the [LOAD] button on this unit, the tracks are analyzed, but it may take time to finish the analyzing tracks and to display the BPM and waveform. When the Serato DJ Pro software is used as an offline player, tracks can be analyzed ahead of time. For tracks whose analysis has been completed, the BPM and waveform are displayed immediately when the tracks are loaded onto the decks. For details on using the Serato DJ Pro software as an offline player and instructions on analyzing tracks, see the Serato DJ Pro software manual. ! Depending on the number of tracks, it may take time for analysis. Using effects Serato DJ Pro has two effects units, FX1 and FX2. Those effects can be applied to the selected deck. The following describes how to operate this unit to assign an effect unit to channel 1 (FX1). Serato DJ Pro effects unit screen display Multi FX mode: Up to three effects can be selected per effect unit, and each effect has one adjustable parameter. ! The number of the deck to which the effect is assigned is highlighted on the Serato DJ Pro screen. 3 Press the effect parameter 1 button while pressing the [SHIFT] button to select the first effect type. To select the second effect type, press the effect parameter 2 button while pressing the [SHIFT] button. To select the third effect type, press the effect parameter 3 button while pressing the [SHIFT] button. ! The currently selected effect type is displayed on the Serato DJ Pro screen. 26 En
Download PDF file
Table of contents