Before you start Installing the software About the driver software (Windows) This driver software is an exclusive ASIO driver for outputting audio signals from the computer. ! There is no need to install the driver software when using Mac OS X. 2 Slide this unit’s [ON/OFF] switch to the [ON] position. Turn on the power of this unit. ! The message [Installing device driver software] may appear when this unit is first connected to the computer or when it is connected to a different USB port on the computer. Wait a while until the message [Your devices are ready for use] appears. Adjusting the buffer size This unit functions as an audio device conforming to the ASIO standards. ! If an application using this unit as the default audio device (DJ software, etc.) is running, quit that application before adjusting the buffer size. Operating environment Supported operating systems Windows® 7 Home Premium/Professional/ Ultimate Windows Vista Home Basic/ Home Premium/Business/Ultimate Windows® XP Home Edition/Professional (SP2 or later) ® 32-bit version 64-bit version 32-bit version 64-bit version 32-bit version 1 1 1 1 1 1 1 Click the Windows [Start] menu>[All Programs]> [Pioneer]>[DDJ_WeGO]>[DDJ_WeGO ASIO Settings Utility]. 1 When using a 64-bit version of Windows, the driver software can only be used for 32-bit applications. Before installing the driver software ! ! ! ! First read the Software end user license agreement on page 19 carefully. Turn off this unit’s power switch, then disconnect the USB cable connecting this unit and the computer. If any other programs are running on the computer, quit them. To install or uninstall the driver software, you need to be authorized by the administrator of your computer. Log on as the administrator of your computer before proceeding with the installation. If you connect this unit to your computer without installing the driver software first, an error may occur on your computer depending on the system environment. If installation of the driver software is interrupted after it has started, start the installation procedure over again from the beginning. ! ! Installing the driver software 1 Turn on the computer’s power. 2 Insert the included CD-ROM into the computer’s CD drive. 3 When the CD-ROM menu appears, select [Install Driver Software (Pioneer_DDJ_WeGO_Driver_X.XXX)], then click [Start]. 4 Proceed with installation according to the instructions on the screen. If [Windows Security] appears on the screen while the installation is in progress, click [Install this driver software anyway] and continue with the installation. ! When installing on Windows XP If [Hardware Installation] appears on the screen while the installation is in progress, click [Continue Anyway] and continue with the installation. ! When the installation program is completed, a completion message appears. ! If the buffer size is made large, drops in audio data (breaks in the sound) occur less easily, but the time lag due to the delay in the transfer of the audio data (latency) increases. If the kernel buffer number is made large, breaks in the sound occur less easily, but the time lag due to latency increases. Operate referring to the procedure below to adjust the buffer size and kernel buffer. ! ! If there are no interruptions in the sound with the default settings 1 Gradually decrease the buffer size, setting it to the minimum value at which there are no interruptions in the sound. 2 Set the kernel buffer size to [2] and check whether there are interruptions in the sound. — If there are interruptions in the sound, set the kernel buffer size to [3]. If there are interruptions in the sound with the default settings 1 Set the kernel buffer size to [4], then set the buffer size to the minimum value at which there are no interruptions in the sound. Connecting this unit and computer 1 Connect this unit to your computer via a USB cable. For instructions on connections, see Connecting the input/output terminals on page 7. 4 En
Download PDF file