If you want to dispose this product, do not mix it with general household waste. There is a separate collection system for used electronic products in accordance with legislation that requires proper treatment, recovery and recycling. Private households in the 25 member states of the EU, in Switzerland and Norway may return their used electronic products free of charge to designated collection facilities or to a retailer (if you purchase a similar new one). For countries not mentioned above, please contact your local authorities for the correct method of disposal. By doing so you will ensure that your disposed product undergoes the necessary treatment, recovery and recycling and thus prevent potential negative effects on the environment and human health. Features • The flat-panel speaker system allows sound to radiate from the whole of the front and rear surface of the speaker. This produces a uniform sound across the whole listening area. • The speaker can be used with a third-party speaker stand in a variety of configurations - vertically, horizontally and so on. • The speaker is magnetically shielded. The S-FL1 speaker is a flat-panel type unit that uses NXT® speaker technology. This slim style speaker allows for easy installation anywhere. NXT and the logo are registered trademarks of New Transducers Limited. • This speaker’s nominal impedance is 8 ohms. Please use a power amplifier rated between 4 and 16 ohms. • If you are using a stand, metal fittings, etc. with the speaker, please make sure that they are of sufficient strength to carry the load. • Do not install the speaker near a heater or in direct sunlight. Before you install • The sound of the speaker may be subtlely affected by the listening room conditions. Please take this into account when installing the speaker in order to get the best performance from it. • The speaker weighs 9.9 kg. Please make sure that you choose a stable surface that is far enough from rear and side walls (see the diagram below). Adjust the position so that the left and right walls do not adversely affect the sound. Supplied accessories There are no supplied accessories with this speaker. Caution About installation • This equipment should only be installed by a suitably experienced and qualified person. Please have installation and setting up carried out by factory or sales staff. • Pioneer is in no way responsible for accidents, injury or damage caused by incorrect installation/setting up, misuse, modification or natural disasters. • Before wall- or ceiling-mounting this speaker, please make sure that the wall or ceiling is strong enough to support the speaker's weight (9.9 kg). If you are in doubt, please consult a specialist. Serious injury could result if the speaker were to fall. • Please do not attempt to detach the grille; the diaphragm may be damaged as a result. at least 50cm at least 50 cm • The minimum distances in the above diagram are just a guide; the acoustic properties of the wall will affect the best placement. • In general, the more acoustically absorbant the wall, the less bass frequencies will be affected, even when the speaker is placed close to a wall. • Two M8 diameter screw holes for mounting the speaker can be found on the top, bottom and both sides of the speaker. There are also four M6 diameter screw holes on the rear panel; please remove the caps before use. 2 En
Download PDF file