English Français Rear panel (subwoofer model) 4 3 Installation and connections Important notes on installation The sound produced by the speaker is subtly influenced by the conditions of the room you use it in. Carefully consider the installation location before 7 setting up the speaker to ensure the best possible conditions. 6 AoflpthheaTshpeetaakCero(ripnocrlautdioinngwbiulltnnoottbleimliiatebdletofolrosasnyofdbaumsaingeesssaoripspinogrtufrnoimtieuss),e 5 regardless of the installation method used. a Be sure to use the handles on the top or the sides of the speaker when 8 moving and installing it. 9 CAUTION To help proper cooling, please make sure enough space is kept between each speaker and nearby walls or other components (minimum 30 cm or more above, behind, and to the sides of each speaker). Leaving insufficient space may cause the temperature inside the speaker to rise, leading to malfunction or permanent damage. Deutsch Italiano Nederlands Español Português Русский 1 2 1 AC INPUT The AC connection is established via the IEC connector. The IEC connector is compatible with a lockout power cord (not included). 2 POWER AC switch for turning the power on or off. When POWER is turned on, the LED lights up. 3 LINK The XLR output sends mixed input signals to other speakers or subwoofers. VOLUME (input level) controls the level of signal sent to LINK. The MASTER VOL and DSP control settings do not affect the LINK signal. 4 INPUT LEFT (mono)/RIGHT 5 POWER indicators The POWER LED lights up when the speaker is turned on. 6 SIG/LIMITER signal light Lights up green when there is a signal, and red when the amplifier starts to compress. 7 3DSP PRESET MODES BOOST/EXTENDED LF/NORMAL 8 LPF 80 Hz/100 Hz/120 Hz 9 POLARITY REVERSE/NORMAL a VOLUME Level control of an input signal. Installation using a speaker pole XPRS102/XPRS122 The full-range models of the XPRS2 Series have a 35-mm-diameter pole socket on the bottom surface. The subwoofer model of the XPRS2 Series have a 35-mm-diameter pole socket on the top surface in which the pole can be secured firmly. The combinations shown in the following diagrams are recommended for the XPRS2 Series. Using a different combination may result in the speakers toppling over and possibly causing damage or injury. To use a speaker pole, check the cautions below and perform the installation safely. CAUTION • At least two people should lift each speaker together to install it. Be sure to give enough consideration to safety when performing the work. • Use a 35-mm-diameter speaker pole. Use a commercially-available product with a length of 900 mm or less. AlphaTheta Corporation will not be liable for any damages (including but not limited to loss of business opportunities) arising from the use of a speaker pole other than the type specified. • Install the subwoofer in a stable location and secure the speaker pole firmly. • Ensure there is no danger of speakers toppling over. • Cables should be taped or tied together with suitable tape or cable ties to avoid the danger of tripping on the cables and causing the speakers to topple over. Pole socket Front 35-mm-diameter pole socket Pole socket Installation using a speaker pole XPRS102, XPRS122 XPRS1152S, XPRS1182S En 3 简体中文
Download PDF file
Table of contents