Pioneer DJ

Pioneer DJRear panel 1 2 3 4 567 8 76 9a b c d e 1 Kensington security slot 2 MASTER 1 output terminal Connect a powered speaker, a power amp, etc. ! Compatible with XLR connector type balanced outputs. Be sure to use these as balanced outputs. ! Be careful not to accidentally insert the power cord of another unit. ! Do not connect a terminal that can supply phantom power. 3 MASTER 2 output terminal Connect a powered speaker, a power amp, etc. ! Compatible with RCA pin-jack type unbalanced outputs. 4 BOOTH output terminal Output terminals for a booth monitor. ! Compatible with TRS connector type balanced outputs. Be sure to use these as balanced outputs. ! The master channel sound can be output from the [ BOOTH ] output terminals regardless of the audio level set for the master channel. The sound level can be adjusted using the [ BOOTH MONITOR LEVEL ] control. 5 SIGNAL GND terminal Connect a ground wire of an analog player to reduce noise that occurs when an analog player is connected. 6 LINE/PHONO switch Selects the input source for each channel from the components connected to this unit. ! [ LINE ]: Uses a line level output device (DJ player, etc.) connected to the [ LINE/PHONO ] input terminals. ! [ PHONO ]: Uses a phono level (for MM cartridges) output device (analog player, etc.) connected to the [ LINE/PHONO ] input terminals. 7 LINE/PHONO input terminals Connect a phono level (for MM cartridges) output device (analog player, etc.) or a line level output device (DJ player, etc.). Switch the input source according to the connected device using the [ LINE/PHONO ] switch on the rear panel of this unit. ! Set the [ USB A, PHONO/LINE, USB B ] selector switch on top of the unit to [ PHONO/LINE ] beforehand. 8 LINE input terminals Connect to a DJ player or other line level device. ! Set the [ USB A, LINE, USB B ] selector switch on top of the unit to [ LINE ] beforehand. 9 USB terminals (USB B) Connect to a computer. ! Connect this unit to your computer directly via the USB cable included with this product or one that conforms to USB 2.0. ! Do not use a USB hub. a USB terminals (USB A) Connect to a computer. ! Connect this unit to your computer directly via the USB cable included with this product or one that conforms to USB 2.0. ! Do not use a USB hub. b MIC2 input terminals Connect a microphone. ! Only phone plugs (Ø 6.3 mm) can be used. c MIC1 input terminals Connect a microphone. ! Either an XLR connector or a phones plug ( Ø 6.3 mm) can be used. d u switch Turns this unit on or puts this unit into standby mode. e DC IN terminal Connect to a power outlet using the included AC adapter (with the included power cord connected). ! Connect the AC adapter after all the connections between devices are completed. ! Use the included AC adapter. f DC cord hook Hook for the AC adapter power cord. ! If the AC adapter is disconnected during playback, the sound will be interrupted. 10 EnPage 2