Page number 6
Step 1 Installing rekordbox If you are installing rekordbox for the first time or are upgrading from rekordbox 3 or earlier, use the following procedures. If you have installed rekordbox 4 already, update it to the latest version. Downloading rekordbox Access “rekordbox.com”. http://rekordbox.com/en/store/ • The site is subject to change without notice. After reading the Get Started guide, click [Free To Download]. Read the terms of the software license agreement carefully, and then mark the [Agree] checkbox to continue. After marking the checkbox, click [ Download ] to start downloading rekordbox. Installing (Windows) • Log into your computer as administrator before starting the installation. 1 Unzip the downloaded rekordbox software file. 2 Double-click the unzipped software file, and then start the installer. 3 Read the terms of the license agreement carefully, and then click [Agree] to continue. Installing rekordbox Depending on the Operating System (OS) of your computer, procedures differ. Do not connect the unit to your computer until the installation has completed. Installing (Mac OS X) 1 Unzip the downloaded rekordbox software file. 2 Double-click the unzipped software file, and then start the installer. 3 Read the terms of the license agreement carefully, and then click [Agree] to continue. • If you do not agree to the contents of the license agreement, click [ Cancel ] to cancel the installation. After specifying the destination, the installation will be started. When the installation is finished, a completion message will be displayed. 4 Click [Finish] to complete the installation. • If you do not agree to the contents of the license agreement, click [ Disagree ] to cancel the installation. 4 When the screen for completing the installation appears, click [Close] to end the installation. 6 En
Page number 7
English Step 2 Connecting devices and this unit Names of Parts For details, see the Operating Instructions of this unit. TEMPO slider FX LEVEL control FX BEAT setup buttons FX ON/OFF button USB terminal MASTER output terminals MIC input terminal (1/4” TS jack) *Supported unbalanced input only MIC LEVEL control *When not using a microphone, turn the volume to the minimum level. LOAD button TRIM control Rotary selector EQ ( HI / MID / LOW ) controls MASTER LEVEL control HEADPHONE LEVEL control FILTER control HEADPHONES CUE MASTER/1/2 select button Jog dial Pad mode select button Performance pad CHANNEL LEVEL indicator Crossfader Channel fader Deck 2 (right) SHIFT button SYNC button CUE button PLAY/PAUSE f button LOOP IN/OUT button Deck 1 (left) PHONES output terminal (3.5 mm stereo mini jack) Connecting speakers with a built-in amplifier to the unit with an audio cable (RCA) Connect speakers with a built-in amplifier, powered speakers, etc. to the [MASTER] output terminals of this unit. Connecting your computer to the unit 1 Connect your computer to the unit via a USB cable. Make a direct connection with the supplied USB cable. A USB hub cannot be used. Speakers with a built-in amplifier, powered speakers, etc. USB cable (supplied) Computer • For details on connecting the input/output terminals, see the Operating Instructions of this unit. • Turn the volume of the device(s) (speakers with a built-in amplifier, powered speakers, etc.) connected to the [ MASTER ] output terminals to an appropriate level. Note that the output sound may be loud if the volume is set too high. 2 Turn on your computer. 3 Turn on the device(s) (speakers with a built-in amplifier, powered speakers, etc.) connected to the output terminal. En 7
