Changing the settings Changing the settings Launching utilities mode If the utilities mode is launched while the DJ application is running, the set status may not be displayed properly. 1 Disconnect the USB cable from your computer. 2 Press the [u] switch on this unit’s rear panel to set this unit’s power to standby. Set this unit’s power to the standby mode. 3 While pressing both the [SHIFT] and [PLAY/PAUSE f] buttons on the left deck, press the [u] switch on this unit’s rear panel. Utilities mode is launched. 4 After setting this unit to the utility settings mode, operate the controller for the item whose settings you want to change. See the explanations below for the settings that can be changed. 5 Press the [u] switch on this unit’s rear panel to set this unit’s power to standby. To save the settings, set the [u] switch on this unit’s rear panel to standby and quit utilities mode. Utilities modes The following settings can be changed: ! MIDI controller setting ! Fader start setting ! Master output attenuator level setting ! Slip mode flashing setting ! Demo mode setting ! Setting of the velocity curve in the sampler velocity mode ! Sampler velocity mode after-touch setting ! Setting of the auto standby function ! Setting of talk over function ! Setting of talk over function level ! Cut lag setting of crossfader ! Output setting of microphone to booth monitor ! Peak limiter setting ! Brightness setting of jog ring Changing the fader start setting The fader start function’s setting can be changed. ! By default, the fader start mode functions without the sync mode set. Press one of the effect parameter buttons on the left deck. ! Effect parameter 1 button lit: Fader start with the sync mode set (The sync function is activated simultaneously when fader starting starts.) ! Effect parameter 2 button lit: Fader start without sync mode set (The sync function is not activated simultaneously when fader starting starts.) ! Effect parameter 3 button lit: Fader start function disabled Setting the master output’s attenuator level ! The default is 0 dB. Press one of the left deck’s [HOT CUE] mode, [ROLL] mode or [SLICER] mode buttons. ! [HOT CUE] mode button lit: 0 dB (no attenuation) ! [ROLL] mode button lit: –3 dB ! [SLICER] mode button lit: –6 dB Changing the slip mode flashing setting When slip mode in on, buttons available in slip mode (such as the jog dial indicator, [AUTO LOOP] button, and [PLAY/PAUSE f] button) can be set to flash or not flash. The flashing method used for the [SLIP] button during slip mode changes depending on the setting. ! By default, slip mode flashing is set to mode 1. Press the performance pad on the left side to select a setting. The currently selected setting can be understood by looking at which pad lights. Forcefully using the unit as the general MIDI controller The unit automatically changes operation as follows depending on whether Serato DJ is running. ! When Serato DJ is running, controller operation depends on the Serato DJ functions. ! When Serato DJ is not running, the unit operates as a general MIDI controller. Even though Serato DJ is running, you can forcefully operate the unit as a general MIDI controller. Press the [KEY LOCK] button on the left deck. ! [KEY LOCK] button off: Operation automatically changes depending on whether or not Serato DJ is running. ! [KEY LOCK] button lit: Regardless of whether or not Serato DJ is running, the unit is forcefully operated as a general MIDI controller. Mode 1 Mode 2 Off ! Mode 1: When slip mode is turned on, the buttons available in slip mode flash for approximately one second. During slip mode, the [SLIP] button flashes only while payback continues in the background. ! Mode 2: When the slip mode is turned on, the buttons available in slip mode flash for approximately one second. During slip mode, the [SLIP] button continues flashing. ! Off: The buttons available in slip mode do not flash. During slip mode, the [SLIP] button flashes only while payback continues in the background. En 27
Download PDF file
Table of contents