Connections and part names Connections and part names Connections ! Connect the power cord after all the connections between devices have been completed. Be sure to turn off the power and unplug the power cord from the power outlet whenever making or changing connections. Refer to the operating instructions for the component to be connected. ! Be sure to use the included power cord. ! Be sure to use the USB cable included with this product or the one that conforms to USB 2.0. Names of Parts Rear panel 1 2 3 4 5 6 7 88 6 7 5 9 a b c d e 1 Kensington security slot 2 MASTER 1 terminals Connect powered speakers, etc., here. ! Compatible with XLR connector type balanced outputs. 3 MASTER 2 terminals Connect to a power amplifier, etc. ! Compatible with RCA pin-jack type unbalanced outputs. 4 BOOTH terminals These are the output terminals for a booth monitor. Compatible with balanced or unbalanced output for 1/4” TRS connectors. The master channel sound can be output from the [BOOTH] output terminals regardless of the audio level set for the master channel. The volume level can be adjusted with the [BOOTH MONITOR] control. ! The sound will be distorted if the level is raised too high when using unbalanced outputs. 5 SIGNAL GND terminal Connects an analog player’s ground wire here. This helps reduce noise when the analog player is connected. 6 PHONO terminals Connect to a phono level (MM cartridge) output device. Do not input line level signals. ! You need to set the [LINE, PHONO, USB] selector switch on top of the unit to [PHONO] beforehand. 7 LINE terminals Connect to a DJ player or other line level device. ! You need to set the [LINE, PHONO, USB] selector switch on top of the unit to [LINE] beforehand. 8 CD terminals Connect to a DJ player or other line level device. ! You need to set the [CD, USB] selector switch on top of the unit to [CD] beforehand. 9 MIC1 terminal Connects a microphone here. ! Either an XLR connector or a phones plug (Ø 6.3 mm) can be used. a MIC2 terminal Connects a microphone here. Compatible with a 1/4” TS jack. b USB-B terminal Connect to a computer. ! Connect this unit to your computer directly via a USB cable included with this product or the one that conforms to USB 2.0. ! A USB hub cannot be used. c USB-A terminal Connect to a computer. ! Connect this unit to your computer directly via a USB cable included with this product or the one that conforms to USB 2.0. ! A USB hub cannot be used. d u switch This switches this unit’s power between on and standby. e AC IN terminal Connect the power cord after all the connections between devices have been completed. Be sure to use the included power cord. En 7
Download PDF file
Table of contents