Rear Panel Facilities a 9 8 1 Bass-reflex duct “Vortex bass accelerator” structure of the bass-reflex duct to achieve high-speed deep bass reproduction. 2 Switch for switching HIGH EQ 1 Use to switch between four types of EQ setting: ROOM 1, FLAT, ROOM 2, and BRIGHT TREBLE. For details see “DSP CONTROL” on page 4. 3 Switch for switching LOW EQ Use to switch between four types of EQ setting: ROOM 1, FLAT, ROOM 2, and CLUB BASS. For details see “DSP 2 CONTROL” on page 4. 3 4 AUTO STANDBY switch Use to turn the auto standby function on or off. 4 When the auto standby function is turned on, the speakers automatically enter standby mode if no input signal is 5 received for a certain period of time (approximately 25 minutes) and power consumption can be reduced. When an 6 input signal is received while the speakers are in standby mode, the speakers will automatically resume from standby mode. 7 • The POWER indicator on the front panel is lit in red during standby mode. • When the input signal is weaker than a certain level, the speakers may not automatically resume from standby mode. In such cases, turn off the [AUTO STANDBY] switch to use the speakers. • To force the speakers to resume from standby mode, turn off the [POWER] switch on the rear panel once, and turn it back on after a few seconds. 5 VOLUME dial Use to adjust the sound level (volume). 6 AC IN Connect the accessory power cord here and to an AC power outlet. Do not plug in the power cord until all other connections have been completed. Use only the furnished accessory power cord. 7 Fuse holder 8 POWER switch Use to turn the power on and off. 9 RCA INPUT jack RCA pin-type unbalanced input jacks. a XLR/TRS INPUT jack Both XLR jack (balanced) and 1/4” TRS (balanced type PHONO) are supported. The XLR jack arrangement is Pin 1 Ground, Pin 2 Hot, and Pin 3 Cold. 3
Download PDF file
Table of contents