Loading tracks via the wireless LAN ! ! To load tracks from sources other than mobile devices, see the operating instructions on the included CD-ROM. For instructions on loading tracks from a computer via wireless LAN, also see “Playback connected to a LAN” in the Operating Instructions of rekordbox (Mac/Windows). Outputting sound Set the volume of the power amplifiers connected to the [MASTER OUT 1] and [MASTER OUT 2] terminals to an appropriate level. Note that very loud sounds will be output if the volume is set too high. When playing tracks via wireless LAN, playback may become impossible due to deterioration of the communication conditions. In this case, loop playback begins automatically and [EMERGENCY LOOP] is displayed on the main unit display. When communications conditions recover, the [EMERGENCY LOOP] display turns off. Press the [AUTO BEAT LOOP] control at this time to cancel looping. 1 Launch rekordbox on the mobile device and establish the link. To output the sound of channel 1 [CH 1] To output the sound of [CH 2] (channel 2), replace [CH 1] with [CH 2] and [DECK1] with [DECK2] in the procedure below. 1 Switch the [DECK1, PHONO1/LINE1] selector switch for [CH 1] to [DECK1]. 2 Press the [MASTER] button at the center of this unit. Set so that the [MASTER] button is off. ! When the [MASTER] button is off, the audio level input to [CH 1] and [CH 2] is displayed on the [LEVEL] indicator. 3 Turn the [CH 1] [TRIM] control clockwise. 2 Operate rekordbox on the mobile device to select the track. Adjusts the audio level input to the [CH 1] terminal. The [LEVEL] indicator lights when sound is properly being input to [CH 1]. Adjust the [TRIM] control so that the orange indicator lights where the track’s volume is highest (at the climax, etc.) Be careful that the red indicator does not light, or the sound could be distorted. 4 Move the [CH 1] channel fader to the back side. The level of the sound output from the [CH 1] terminals is adjusted. 5 Set the crossfader. 3 Operate rekordbox on the mobile device to select the deck on which the track is to be loaded, then tap. Switch the channel whose sound is output from the speakers. — Left edge: The [CH 1] sound is output. — Center position: The sound of [CH 1] and [CH 2] is mixed and output. — Right edge: The [CH 2] sound is output. 6 Press the [MASTER] button at the center of this unit. Set so that the [MASTER] button is lit. ! When the [MASTER] button is lit, the audio level output from the [MASTER OUT 1] and [MASTER OUT 2] terminals is displayed on the [LEVEL] indicator. 7 Turn the [MASTER LEVEL] control clockwise. Sound is output from the speakers. The [LEVEL] indicator lights. Adjust the [MASTER LEVEL] control so that the orange indicator lights where the track’s volume is highest (at the climax, etc.) Be careful that the red indicator does not light, or the sound could be distorted. Additional information Track loading starts. The jog dial indicator on the deck on which the track is being loaded flashes. Once playback is possible, the jog dial indicator stops flashing, remaining lit, the track name is displayed on the main unit display and playback starts (by factory default). Read Software end user license agreement carefully before installing rekordbox (Mac/Windows) and the driver software. Read “Cautions on installing the software” in the operating instructions on the included CD-ROM before installing rekordbox (Mac/Windows) and the driver software on the computer. Software end user license agreement This Software End User License Agreement (“Agreement”) is between you (both the individual installing the Program and any single legal entity for which the individual is acting) (“You” or “Your”) and PIONEER CORPORATION (“Pioneer”). 4 En
Download PDF file