Rear Panel Facilities (Full-Range Models) 4 c 5 6 d e 7 7 8 f 1 9 9 2 3 a a b b g 1 POWER switch Turns this speaker’s power on and off. 2 AC IN Connect the power cord to AC IN and then to the power outlet. 3 Fuse holder 4 Power indicator Lights in blue when the power is turned on. 5 MASTER LEVEL Adjusts the output level. 6 EQ MODE SELECT Switches to four EQ modes (FLAT, BASS+, SPEECH, and WEDGE). For details, see “EQ MODE Settings” on page 6. 7 INPUT LEVEL knob Adjusts the input signal level. 8 GAIN knob (for MIC/LINE1 only) Select the gain according to the output signal level of the device to be connected. The selected gain is added to the signal input to this unit. • To input the signal of a line output device to this speaker, select [0 dB] or [12 dB]. • To input a low-level output signal such as that of a microphone to this unit, select [24 dB] or [36 dB]. 9 SIGNAL indicator A green indicator lights when an input signal is detected. a MIC/LINE1 and LINE2 INPUT Both the XLR connector (balanced) and 1/4” TRS (balanced type PHONO) are supported. The XLR connector consists of 1 “ground,” 2 “hot,” and 3 “cold.” b LINK This is the XLR output connector (balanced). A signal input to XLR INPUT will be output directly. (A signal input to AUX IN of LINE2 will not be output.) c LIMIT indicator Lights in red when the built-in limiter is activated or when the input level is too high and the sound is distorted. When that happens, lower the output level of the connected device or lower the input level or master level of this unit. d EXT SUB MODE Select [ ]for normal use. Select [ ] when using a subwoofer. e FRONT LED Selects the display setting of the FRONT LED indicator (white). [POWER] Lights when the power is turned on. [LIMIT] Lights when the limiter is activated. [OFF] The FRONT LED does not light. f AUX IN These are the RCA input connectors (unbalanced). A stereo signal input to AUX IN is mixed to a monaural signal (not output from the LINK connector). g MIX OUT This is the XLR output connector (balanced). Mixes the signal input to MIC/LINE1 and Line2 and then outputs it. A signal adjusted in MIC GAIN and INPUT LEVEL is output. CAUTION When the FRONT LED setting is set to [OFF] and [LIMIT], the speaker may appear the same as when the power plug is disconnected from the power outlet depending on the specification of the product, but the power is not shut off. If you wish to shut off the power to the woofer completely, you must disconnect the power plug from the power outlet. Install the speaker near a power outlet so the power plug can easily be accessed. Leaving the power plug inserted in a power outlet for a long period of time may cause fire. 3
Download PDF file
Table of contents