Page number 6
Connections Be sure to turn off the power and unplug the power cord from the power outlet whenever making or changing connections. Refer to the operating instructions for the component to be connected. Connect the power cord after all the connections between devices have been completed. Be sure to use the included power cord. Names of terminals Rear panel AC IN MASTER OUT 1 2 L CH-2 PHONO CD L SIGNAL GND CH-1 PHONO CD L AUX L MIC CONTROL CONTROL R R R R 1 2 3 4 563 4 5 7 8 9 1 AC IN Connect to an AC outlet. Plug in the power cord after all connections have been made. Be sure to use the included power cord. 2 MASTER OUT 1, 2 (page 7) Connect to a power amplifier, etc. 3 PHONO (page 7) Connect to an analog player or other phono level (MM cartridge) output device. Do not connect to a DJ player or other line level device. 4 CD (page 7) Connect to a DJ player or other line level device. 5 CONTROL (page 7) Connect using a control cord (included with Pioneer DJ players). 6 SIGNAL GND (page 7) Connect an analog player’s ground wire here. This helps reduce noise when the analog player is connected. 7 AUX (page 7) Connect to the output terminal of an external device (sampler, por- table audio device, etc.) 8 MIC (page 7) Connect to a microphone. 9 Kensington security slot Front panel a a PHONES (page 7) Connect headphones here. 6 En
Page number 7
English Connecting the input/output terminals ! When creating a DVS (Digital Vinyl System) combining a computer, audio interface, etc., be careful in connecting the audio interface to this unit’s input terminals and in the settings of the input selector switches. Also refer to the operating instructions of the DJ software and audio interface. Rear panel To power outlet Power cord (included) Component, amplifier, powered speaker, etc. Audio cable To audio input terminals R L RL AUDIO OUT CONTROL USB Example: CDJ-350 DJ player AC IN Audio input section MASTER OUT 1 2 L L CH-2 PHONO CD L L SIGNAL GND CH-1 PHONO CD L L AUX L L MIC R R CONTROL R R CONTROL R R R R Audio output section Audio cable Control cord 1 Ground wire To ground wire terminals Audio cable To audio output terminals Audio cable 2 To audio output terminals Microphone cable To microphone Analog player Portable audio device Microphone 1 To use the fader start function, connect a control cord (page 10). The fader start function can only be used when connected to a Pioneer DJ player. 2 A portable audio device can be connected using an RCA pin - mini-plug ( Ø 3.5 mm) converter cable (page 11). Front panel Headphones Headphones cord En 7
