Mixer section ij ji h 1 g kkkk 2 llll f 3 e mmmm 4 d 5 n n nn c o o oo 6 b 7 pppp a qqqq 8 9 r s 1 MASTER LEVEL control 2 MASTER CUE button 3 Master level indicator 4 BOOTH MONITOR control 5 MASTER OUT COLOR control 6 OSCILLATOR SELECT buttons 7 OSCILLATOR VOLUME control 8 OSCILLATOR PARAMETER control 9 OSC ASSIGN selector switch a HEADPHONES LEVEL control b HEADPHONES MIXING control c SOUND COLOR FX buttons d MIC COLOR control e EQ (HI, LOW) controls f MIC2 control g MIC1 control h OFF, ON, TALK OVER selector switch i LINE, PHONO, USB selector switch j CD, USB selector switch k Channel Level Indicator l TRIM control m ISO (HI, MID, LOW) controls n COLOR control o Headphones CUE button p Channel fader q Crossfader assign selector switch r Crossfader s FEELING ADJUST adjustment hole Front panel Using a microphone 1 Connect a microphone to the [MIC1] or [MIC2] terminal. 2 Set the [OFF, ON, TALK OVER] selector switch to [ON] or [TALK OVER]. — [ON]: The indicator lights. — [TALK OVER]: The indicator flashes. ! When set to [TALK OVER], the sound of channels other than the [MIC1] channel is attenuated by 18 dB (default) when a sound of –10 dB or greater is input to the microphone. ! The sound attenuation level while [TALK OVER] is selected can be changed in utility mode. For the method to effect that change, see Changing the talk over function level on page 29. ! The talk over mode can be switched to the normal mode or the advanced mode. For instructions on changing it, see Changing the talk over function setting on page 2 8. 3 Turn the [MIC1] or [MIC2] control. Adjust the level of the sound output from the [MIC1] channel. ! Pay attention that rotating to the extreme right position outputs a very loud sound. 4 Input audio signals to the microphone. Adjusting the sound quality Turn the [EQ (HI, LOW)] controls. The adjustable ranges for the respective controls are as shown below. ! [HI]: –12 dB to +12 dB (10 kHz) ! [LOW]: –12 dB to +12 dB (100 Hz) Mixing the sound of a DJ player, etc. 1 Connect the DJ player or other line level output device to the [CD] or [LINE] terminals. 2 Set the [LINE, PHONO, USB] selector switch or [CD, USB] selector switch to [LINE] or [CD]. 3 Operate the [TRIM] control and channel fader to adjust the sound level output from each channel. Mixing the sound of an analog turntable, etc. 1 Connect the analog player or other phono level (for MM cartridges) output device to the [PHONO] terminals. 2 Set the [LINE, PHONO, USB] selector switch to [PHONO]. 3 Operate the [TRIM] control and the channel faders to adjust the audio level output from the respective decks. 1 1 CROSS FADER CURVE selector switch 26 En
Download PDF file
Table of contents